Guys, it's been over 50 years since I handloaded .222's for my model 722. I had to sell that rifle because the family was growing and I needed the money. Always regretted it and so I just picked up a Winchester Model 70 XTR in .222 and I'm starting all over again with rifle reloading of any type. I think that a full length resizing die set would cover the situation. I've read a lot about neck sizing but I don't remember doing that my many years ago. I'm going to order new cases and will they need to be resized? I know the inside neck will need to be chamfered and deburred on the outside. I'm going to order a case gauge and trim die and shell holder. I can't think of much else that I'll need other than primers, powder and bullets. So, my inquiry to my fellow THRoaders is please let me know if I need anything other than what I've listed. Any advice is considered helpful.