Remington 1100 question

Status
Not open for further replies.
Joined
Jul 16, 2009
Messages
162
Location
Georgia
My siblings and I have inherited 2 remington 1100's. One is a 12 gauge and one is a 20 gauge. They are both around the same age, probably 1980's. The 20 gauge has "Skeet B" marked on it. The 20 gauge is the one on the bottom.
Could someone tell me the approximate value of these guns? Are they both around the same value?
 

Attachments

  • SDC17516.jpg
    SDC17516.jpg
    89.5 KB · Views: 29
  • SDC17522.jpg
    SDC17522.jpg
    278.7 KB · Views: 30
At a minumum at least $325.00 each.
The pictures of the stocks are not clear enough to tell if they are an 80's made or 70's made 1100.
 
Does the barrel on the 20 gauge (bottom pic) and the "Skeet B" marking make it more valuable?
 

Attachments

  • SDC17524.jpg
    SDC17524.jpg
    278.9 KB · Views: 11
No, that is the choke that is in the barrel mouth, mostly called skeet 2...Skeet is jump above cylinder but below improved cylinder.

Some makers just use Skeet and skeet b. others use skeet, skeet 1 and skeet 2.

The difference is the amount of pellets in a 30" circle at 40 yds.
Cylinder is 40%, Skeet is 45%, Skeet 1 is 46.5%, Skeet 2 is 48% and Imp/Cyl is 50%

Actually it is probably a detriment to the cost as it's a very specific choke for clay bird shooting and isn't going to be of much interest for hunters who are looking to buy shotguns...Limited marketplace! You may get some activity from dove hunters, though.

What's the choke on the 12?

Check the various auction sites or gun dealers online and see what other 1100s went for or asking price---then sell it for 20% less.
 
Last edited:
If the wood is original, the 12 is post 1979, and the 20 is pre 1979. The 20 appears to be a standard (built on the 12 gauge size receiver) and if the serial number ends in 'X' it definitely is. These guns are in rather significant demand by target shooters, and a 'Skeet B' could fetch a premium, depending on condition. Most skeet guns get shot a lot, and the internals may have significant wear. In any event i wouldn't think you would have any trouble selling it if everything is in working order. Skeet stamped on the receiver like yours was a grade, not just a choke marking. For many years the 1100s ruled the skeet fields.
 
If the wood is original, the 12 is post 1979, and the 20 is pre 1979. The 20 appears to be a standard (built on the 12 gauge size receiver) and if the serial number ends in 'X' it definitely is. These guns are in rather significant demand by target shooters, and a 'Skeet B' could fetch a premium, depending on condition. Most skeet guns get shot a lot, and the internals may have significant wear. In any event i wouldn't think you would have any trouble selling it if everything is in working order. Skeet stamped on the receiver like yours was a grade, not just a choke marking. For many years the 1100s ruled the skeet fields.
Remington never offered a Skeet B grade.

From the official Remington 1100 site:

Caliber/Gauge (intoduced):
12 gauge (1963)
16 gauge (1964)
20 gauge (1969)
.410 bore (1969)
Matched Pair in .410 bore & 28 gauge (1970)

# of Grades Offered:
Field
SA Skeet
SC Skeet
TA Trap
TB Trap
TBMC Trap
Tournament Grade Trap
Tournament Grade Skeet
D Tournament Grade
F Premier Grade

Variations:
Magnum Duck Gun
Lightweight 20 gauge in Field, Magnum, Skeet & Deer
150th Anniversary edition – 1966
Matched Pairs in .410 bore & 28 gauge skeet 1970
Left hand in 12 & 20 gauge
Ducks Unlimited Commemorative versions
Bicentennial model
Limited Edition "One of Three Thousand"
Special Field
Special Purpose
Synthetic
Sporting
Classic Field
Youth
 
Usualy the 20ga guns will draw a premium over the 12ga. Vented rib barrels are also slightly more desirable than plain barrels.

20% to 25% more money for the 20ga I think is about right, if conditions are about the same.
 
the choke would be stamped on the barrel, in this case, per picture #2, you can clearly see that "Skeet B" is stamped on the Reciever. Indications of choke would not be stamped on the reciever.

found this - "SKEET" is SKEET-A or field grade, "SKEET-B" is the same with a A grade wood, "SKEET-C" is AA Fancy wood, "SKEET-D" is AA-AAA wood with engraving over top of receiver, back top portion of BBL and trigger guard, and "SKEET-F" is a Premier grade, heavily engraved with AAA Fancy wood. "SKEET-T" is a Tournament grade. According to Remington's historical people all the "skeet" guns had a different drop @ comb, heel and apparently they are back bored BBL's with lengthened forcing cones. All of the same suffix information applies to the trap guns too.

I would call Remington to confirm 1-800-243-9700.
 
Last edited:
The Skeet A and Skeet B guns were identical in stock dimensions with the field guns, and did not have back bored barrels or lengthened forcing cones. My skeet shooting buddy bought a Skeet B about 1965 if I remember right, because he liked my 1963 so much. They did have a middle bead on the vent rib. B had better wood. From grade C on up you got cut checkering. They were standard catalog items for many many years. I shot a many a one and there was not one iota of difference between them and my field gun with a skeet choked factory barrel dimension wise. Also back then the Skeet barrels were 26". That was before the gun writers stated telling everyone we needed longer barrels.
You could get about anything you wanted thru the custom shop for decades.
 
Thanks for the information guys. I was confused because I was looking at a gun value website and several of the Remington 1100's are valued in the $600-$800 range. It is confusing because there are so many different 1100 models. I was wondering if the 20 gauge is in that value range. The serial number on it does end with an "X." Thanks.

SeekHer, I don't know why you say there is no "Skeet B" model because ours clearly has "Skeet B" stamped into the receiver.
 
Last edited:
The "X" in the serial number indicates that it's a 20 gauge. The skeet B grade was no different than the regular field gun except that it had a middle bead on the barrel. The current Blue Book of gun values states they're worth $350 in mint condition. Remington did make what they called a "Tournament Grade" skeet gun but it was similar to the C and D grades with fancy wood and had cut checkering.
 
Thanks for the information guys. I was confused because I was looking at a gun value website and several of the Remington 1100's are valued in the $600-$800 range. It is confusing because there are so many different 1100 models. I was wondering if the 20 gauge is in that value range. The serial number on it does end with an "X." Thanks.

SeekHer, I don't know why you say there is no "Skeet B" model because ours clearly has "Skeet B" stamped into the receiver.

Firstly, you don't mention that it's on the receiver but I got it directly from the source--Remington's own Firearms History fact pages on all the models as indicated in post #8 where I cited them...If you can't believe them then the Hell with it.

The ending serial number "X" indicates that it's using a non proportional or the larger frame to make the smaller bore as virginian stated.

Value is based on condition, scarcity and features...IIRC there are eight levels of condition from NRA NIB to NRA Excellent through NRA Good to NRA "We're not involving ourselves with that"...Actually it's seven and the last one isn't one of them...http://www.armchairgunshow.com/Condition-NRA-Guns.htm.

A firearm still in production will never garner high prices used unless it is unique...My friend contacted a very notable major rifle maker and had them make a specific model, with a few pretty gewgaws, in a specific calibre that they had never chambered any of their rifle models in...They featured it in their "Custom Corner or Shop" catalogue pages and sold a few hundred in total...My friend got almost all his money refunded, was given a few books on the company signed by the authors, a five piece set of hunting knives bearing their logo, some hunting clothes and lastly a couple of T-Shirts and hats as a thank you from them...In fifty years from now those few hundred will garner five to ten times the amount that their sister models will bring.

Pretty and functional with beat out drab and functional every day--so those spacers and vent rib will get you more money.

Your spacers on the grip cap and the vent rib will get you more for the same gun without them.

What is the choke on both guns?

Those fixed chokes get passed over a LOT for detachable ones at about the same or slightly higher price...Long barrels and more open chokes mean target guns that have been shot a lot and long barrels with heavy chokes means waterfowl guns that may not have survived the transition to steel shot too, too successfully.

Are you wanting value for insurance purposes or for what you'll make selling them--Replacement cost for insurance today is $1,359 for the twelve and $1,692 for the twenty MSRP.

There are hundreds of very reputable and trustworthy resellers out there of fowling pieces--a lot they get in trade or estate sales...These guys will give you a good idea of the realized prices that you could get if you sold it to them!

Puglisi
Aspen Outfitting
Bill Hanus
British Sporting
Collector's -- Good selection but the prices seem to be too high for the quality grade if you're buying..
Fieldsport
Griffin & Howe
Harry Marx
Ivory Beads
Kevins
New England Custom Guns
Pacific Sporting
Robin Hollow
Southwest Shooters Supply

You can also try the bespoke makers themselves, they take trades:

Holland & Holland
Westley Richards
 
No offense, but unless it is a personal letter on Remington factory letterhead paper, no, you can't believe them. And I am a solid Remington lover. The famous "call them and get your manufacture date, etc." advice is extremely suspect. They say Remington 1100 serial numbers started with 6 digits, so the 5 digit in my safe, the 4 digit I used to have (Skeet by the way), and the 4 digit I saw with my own eyes are obviously figments of my imagination. And I don't have to look anything up. To quote Elmer, "Hell, I was there."
 
Status
Not open for further replies.
Back
Top