Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Removing the GP100 Trigger Guard Assembly

Discussion in 'Handguns: Revolvers' started by nerd-with-a-gun, Mar 18, 2010.

Thread Status:
Not open for further replies.
  1. nerd-with-a-gun

    nerd-with-a-gun Member

    Joined:
    Nov 8, 2009
    Messages:
    52
    Location:
    North Carolina
    Any tips on how to get this done? I have tried several times to get the trigger guard assembly out and the plunger simply will not budge, no matter how much pressure I apply to it. Any help with this would be greatly appreciated.
     
  2. earlthegoat2

    earlthegoat2 Member

    Joined:
    Aug 28, 2008
    Messages:
    4,514
    Location:
    SE GA
    Have you tried using a lever (screwdriver)

    That is how I do it with the Security Six and the mechanism is similar.
     
  3. nerd-with-a-gun

    nerd-with-a-gun Member

    Joined:
    Nov 8, 2009
    Messages:
    52
    Location:
    North Carolina
    Do you mean inserting the screwdriver and levering up on the tab to remove it? So far I haven't found a screwdriver that is small enough to try this with.
     
  4. earlthegoat2

    earlthegoat2 Member

    Joined:
    Aug 28, 2008
    Messages:
    4,514
    Location:
    SE GA
  5. nerd-with-a-gun

    nerd-with-a-gun Member

    Joined:
    Nov 8, 2009
    Messages:
    52
    Location:
    North Carolina
    I got it! I used a 3mm hex wrench (key) and applied leverage to the plunger and it finally popped. Now I can give my GP100 a polish job.
     
Thread Status:
Not open for further replies.

Share This Page