vanilla_gorilla
Member
- Joined
- Jun 10, 2006
- Messages
- 360
I'm having a problem with my .357 and .38 cases not fitting in the chambers of my GP-100. They fit great and shoot fine in my Model 28-2, but resizing leaves the slightest little "shoulder" just above the rim. Mic'ing the cases shows the resized ones are .001 inch wider than factory cases, which fit fine.
I'm using a Lee carbide die and the "shoulder" is the area covered by the shell holder when the brass is in the shell holder on the press. Any suggestions?
I'm using a Lee carbide die and the "shoulder" is the area covered by the shell holder when the brass is in the shell holder on the press. Any suggestions?