Dr.Zubrato
Member
- Joined
- May 12, 2009
- Messages
- 400
Very recently as in the past few days I purchased a new 20rd pmag, and noticed the bolt catch sometimes would not lock back if I put in the new mag (gently or quickly) and worked the ch handle. I tried this wih a brand new gen2 pmag and it did the same thing! So I took pictures of what was going on
This has never happened at the range, and I've never noticed it before until now. As you can see in the second photo, the bolt caught on the follower before, and when I reinserted a mag minus the upper, I watched the follower catch the bolt release, but then slip off!
I'm thinking this is a bolt catch issue, but this is a relatively new RRA nm lower, and I've never dry fired minus the upper or bcg.
What could've caused this?
Sent from my iPhone using Tapatalk - now Free
This has never happened at the range, and I've never noticed it before until now. As you can see in the second photo, the bolt caught on the follower before, and when I reinserted a mag minus the upper, I watched the follower catch the bolt release, but then slip off!
I'm thinking this is a bolt catch issue, but this is a relatively new RRA nm lower, and I've never dry fired minus the upper or bcg.
What could've caused this?
Sent from my iPhone using Tapatalk - now Free