Ruger All-Weather M77 Mark II Scope Rings Problem

[grimmysnr]

I have a Ruger All-Weather Synthetic M77 Mark II bolt action in .300wm. I am having a problem with the rings practically stripping the finish off my scope. I figured its probably moving under recoil. Iv considered lapping but I was more considering the Burris ZEE signature rings which has the inserts to prevent wear and tear on the scope finish.

I was browsing the web but cant seem to find the rings for my rifle. I do see the ones with the weaver base but cant seem to figure out what conversion to use. The two weaver bases I have found are:

410990: Burris M77b, Super Redhawk Ruger To Weaver Base Adapter

410991: Burris R1, 77/22b, 77MLb, 77/44b, M-14b, Ruger-To-Weaver Base Adapter

But I have no idea what any of that mess means. Do you guys have any suggestions? I just am at a loss on what would fit.

Forgot to mention they are supposed to be 1" rings and I have a Nikon Buckmaster II 3x9x40 scope which should be a 1" tube.

 

[M'bogo]

Burris and Leupold both make rings that fit the Ruger M77 with out the need for an adaptor. I have a Burris set on a M77 and like them much better than the factory rings.

M'bogo

 

[aka108]

Had a similar problem with one of my rifles several years back. Cut some strips of carpet tape and set it inside the rings. Tightened her down and no problems since.

 

[grimmysnr]

Which Burris set do you have?

 

[countryrebel]

They need to be lapped.

 

[M'bogo]

Here is a link to the Burris rings I have on my Ruger.

http://www.swfa.com/pc-1231-826-burris-ruger-style-1-ringmounts.aspx

Good Luck.

M'bogo