?'s On Building an H&K Clone

Status
Not open for further replies.
N

nvrquit

Member
Joined
Dec 24, 2002
Messages
339
Location
Bernville, PA
Please suffer me these inquiries, as this subject has probably been covered a number of times before.

What are the best sources of information on building an H&K from the available components that are on the market? Does this info include the placement/seating of the barrel for headspace in the trunion?

Thanks to all for suffering me in this and for any info passed my way! :)
 
BTDTGTTS

Destructo6,

Been to the forum and there is quite a bit of info there. I was hoping that there might be someone that would know if there is anything for the H&K series like the Kuhnhausen shop manuals. Seems to me that you might almost need a jig to perform some of the welds with a degree of certain accuracy on the H&K.

Thanks all the same!
 
The cocking tube would be the worst part. You'd probably want a jig to ensure it went on straight, but the length appears to be controlled by a shoulder on the receiver end: butt the shoulder to the receiver and weld.

POF-USA has cocking tubes for $75 that appear to be useable.

I don't see anything relating to assembly dimensions in the G3 armorer's manual.

Arizona Response Systems has a sort of pictorial G3 guild under "gunsmithing", then "notes."

IGF, ARS, or AZEX would all be good choices if you don't want to do it yourself.
 
Status
Not open for further replies.
Back
Top