Scope base & scope ring torque values
- Thread starter igotta40
- Start date
- Status
Sav .250
Member
Just do a search on torque specifications for rifle rings/bases. Easy enough to find.
Ring screws can range from 15-25. Most being around 20-23.
Base screws will range from 20ish-25.
Some crossbolt torque values will reach in to the 40's up even to about 65.
All vary depending on manufacturer. Its best to use exactly what the manufacturer recommends,. They usually are written on the package, and if not, you can find them on a search.
Side note, the Wheeler fat wrench is a great choice. Simple and works very well.
Base screws will range from 20ish-25.
Some crossbolt torque values will reach in to the 40's up even to about 65.
All vary depending on manufacturer. Its best to use exactly what the manufacturer recommends,. They usually are written on the package, and if not, you can find them on a search.
Side note, the Wheeler fat wrench is a great choice. Simple and works very well.
- Status