Ohio Gun Guy
Member
I recently bought a M96 mauser that was already drilled and tapped. It has 2 screws in the (Front) reciever and one screw in the rear bridge. I have looked on-line for a specification sheet or something that will tell me the screw pattern for Leupold, Redfield, or b-square (One piece) mounts; However, NOBODY posts this simple information. Do I just have to buy one and see if it fits, or am I really lucky and all manufacturers use a standard screw pattern / spacing?
Anyone with a scoped bolt action care to measure the screw pattern of your scope mount and tell me what manufacturer it is?
Here are the dimentions of mine.
From the rear bridge (Single screw / Center to Center) to the farthest screw:5 - 1/16"
From the rear bridge (Single Screw / Center to Center) to the nearest screw: 4 - 3/16"
Distance between the front 2 screws: 7/8" (14/16")
Any help would be greatly appreciated. I suppose if all else fails I can re-drill the scope mount....
Anyone with a scoped bolt action care to measure the screw pattern of your scope mount and tell me what manufacturer it is?
Here are the dimentions of mine.
From the rear bridge (Single screw / Center to Center) to the farthest screw:5 - 1/16"
From the rear bridge (Single Screw / Center to Center) to the nearest screw: 4 - 3/16"
Distance between the front 2 screws: 7/8" (14/16")
Any help would be greatly appreciated. I suppose if all else fails I can re-drill the scope mount....
Last edited: