PegLegPeat
Member
- Joined
- Mar 6, 2016
- Messages
- 75
I am new to reloading so forgive me for a stupid question. If max case length for a .223 is 1.760, I will set my calipers to 1.759 and lock them in that position and then run my brass through them 1 or 2 at a time as if it were a length gauge. Any that will not fit easily through I will trim. It goes a lot faster than adjusting the calipers and actually measuring each peice. I have been watching a lot of videos and doing a fair bit of reading, but have not seen anyone using this method. Is there some reason my method is flawed?
Thanks in advance
-Peat
Thanks in advance
-Peat