Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

sks receiver pin

Discussion in 'Rifle Country' started by mcb-10, Dec 24, 2011.

Thread Status:
Not open for further replies.
  1. mcb-10

    mcb-10 Member

    Joined:
    Dec 24, 2011
    Messages:
    6
    on a yugo sks,if you remove the nub on the receiver pin lever,are their good replacements pins?
     
  2. bejay

    bejay Member

    Joined:
    Aug 2, 2008
    Messages:
    246
    the ncstar one worked fine for a norinco that I had to replace.
     
  3. mcb-10

    mcb-10 Member

    Joined:
    Dec 24, 2011
    Messages:
    6
    i'm interested in the techsight t-200,but i'm leery of grinding the keeper nub off the lever pin.also i wish you didn't have to use a screwdriver to take the receiver off.my yugo was not cycling so i installed new murray chrome slightly oversized gas valve.it worked great after that also new spring fireing pin.
     
Thread Status:
Not open for further replies.

Share This Page