Plastikosmd
Member
- Joined
- Oct 16, 2011
- Messages
- 828
I swear I posted on takedown of this smith on this forum but I can't find it. Anyway I got it apart. The hang up in the end, the recoil spring had been trimmed and the free end of the spring walked over the recoil rod. The other issue was the hammer sear? Was way too light, a sharp blow would drop the hammer.
I filed in a new engagement and adjusted. She is firing but I think I overstreched the recoil spring or need to use a stiffer load (2.7 gr bullseye) as the gun would cock but the slide travel was too short to eject. Still was a good day at the range
Luger is another project, the toggle doesn't want to drop at times and also fte. I can't see where the toggle locks back. Usually dropping the mag and racking the toggle back will drop it, not always though, other time u just need to keep
pulling back and releasing. It was cold today, oil wasn't moving well at 0drg
I filed in a new engagement and adjusted. She is firing but I think I overstreched the recoil spring or need to use a stiffer load (2.7 gr bullseye) as the gun would cock but the slide travel was too short to eject. Still was a good day at the range
Luger is another project, the toggle doesn't want to drop at times and also fte. I can't see where the toggle locks back. Usually dropping the mag and racking the toggle back will drop it, not always though, other time u just need to keep
pulling back and releasing. It was cold today, oil wasn't moving well at 0drg
Last edited: