Fly Navy
Member
This target stand was built on 22 February 2005, in a matter of a few hours. It was designed to hold both steel swinging targets for pistol and rifle, as well as provide a platform to attach paper targets. The following components were used:
Rifle Target
This swinging steel rifle target weighs about 60 lbs and is designed to be used at 100m or greater. It should be useable for a long time.
Pistol Target
These two swinging steel pistol targets are lightweight and are designed to be used at 25m. They're light enough to be easily moved by most medium and large pistol bullets.
Paper Holder
These removeable wood boards are used to staple paper targets in place. They can be used to hold various sizes of paper targets.
- (2) 3/4" x 3/4" x 6' hollow steel rod
- (2) 5/16" round steel rod
- (1) 3/4" x 3/4" x 3' angle iron
- (3) 1/2" x 2" x 2' pine board
- (4) 5/16" eye bolt
- (6) 1/4" 20 bolts w/ washers and wingnut
- (1) 2" x 12" x 9" steel plate
- (2) 1/2" x 10" x 6" steel plate
Rifle Target
This swinging steel rifle target weighs about 60 lbs and is designed to be used at 100m or greater. It should be useable for a long time.
Pistol Target
These two swinging steel pistol targets are lightweight and are designed to be used at 25m. They're light enough to be easily moved by most medium and large pistol bullets.
Paper Holder
These removeable wood boards are used to staple paper targets in place. They can be used to hold various sizes of paper targets.