1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

stevens 87d 22 lr extractor help

Discussion in 'Rifle Country' started by Countryguy1982, Dec 27, 2012.

Thread Status:
Not open for further replies.
  1. Countryguy1982

    Countryguy1982 Member

    Jun 23, 2011
    North Ga
    Bare with me everyone. Im at work and i cant figure out how to upload a pic from my phone.i just got a new 22 rifle im having a fit with. Its a stevens 87d 22. No feeding issues.and the accuracy us fantastic. Every now and then shooting the gun it snaps. About 1 in 10 will snap. From many different brands of ammo. When it snaps. It will fire another round or 2 and then fail to eject the spent case n feed the new round properly. The spent cace wedges at an angle behind the new round. Looking at it wedged. I noticed that the extractor claw in the left side next to the vent has a slightly upwards bend to it. Is the extractor suppose to be like this? Almost like u would think a case got hung n the force if the bolt pushin against it crooked may of bent ut slightly. Or is this design like that. Examing other newer 22s if mine both extractor claws r flush with each other but both look alike. The 2 on the stevens vary in shape a little. I did break it down n clean it. Still does it. Any if you guys that know the old stevens care to throw in some info?gun is starting to look like a fine stevens boat paddle
Thread Status:
Not open for further replies.

Share This Page