Steven Youngblood
Member
- Joined
- Oct 4, 2008
- Messages
- 177
You just cut a strip from a can, slip it into the slot, put the plunger in and wack it with a plastis hammer, and out pops a no 11 cap, use the hole punch to punch out 2 caps from a cap strip and put them in the cap and that's it.
I made 30 in about 15 minutes including cutting the can into strips.
Lets see obammy stop me now!
I can make powder, shot and caps.
He can bite my big ole American Butt
I just made 30 caps.
The hardest part is getting the snapcaps seated inside the cap.
It took a few tries to get the first ones right, then after that, I got the hang of it .
Keep a pair of tweezers on hand.
I wonder what would happen if I put a small amount of powder in and then seated a cap over it.(did not work.)
I'm going to have to revise my opinion.
I am starting to get failures.
The first 6 must have been a fluke.
Only about half are setting off a charge now.
I will up the caps to 3 per cap
Guys, I'm sorry to say, the results with the chineese caps are not good.
I am going to try to find some made in U.S..
But the caps do not split like the CCI caps.
Now if I can get the power I need. I will update as soon as I get the result.
I made 30 in about 15 minutes including cutting the can into strips.
Lets see obammy stop me now!
I can make powder, shot and caps.
He can bite my big ole American Butt
I just made 30 caps.
The hardest part is getting the snapcaps seated inside the cap.
It took a few tries to get the first ones right, then after that, I got the hang of it .
Keep a pair of tweezers on hand.
I wonder what would happen if I put a small amount of powder in and then seated a cap over it.(did not work.)
I'm going to have to revise my opinion.
I am starting to get failures.
The first 6 must have been a fluke.
Only about half are setting off a charge now.
I will up the caps to 3 per cap
Guys, I'm sorry to say, the results with the chineese caps are not good.
I am going to try to find some made in U.S..
But the caps do not split like the CCI caps.
Now if I can get the power I need. I will update as soon as I get the result.
Attachments
Last edited: