Dave Markowitz
Member
BATF approved the Form 1 on 7/19 that I filed in April and I found out earlier this week. (ATF didn't email me the approved F1 with stamp, like they are supposed to. I found it sitting in my account when I logged into atfonline.gov.)
Tonight I engraved the receiver and chopped the barrel to 12.4". I cut it a little long with a hacksaw, then faced and crowned the barrel in my lathe. The barrel is ~19.5mm in diameter, so it just fit through the 20mm spindle bore. The barrel steel cut easily with a carbide indexable insert while turning at ~450 RPM.
Aside from looking right, it handles a lot better. It's still heavy but the balance is much better without the extra 4.5" of barrel sticking out on the end. I'm looking forward to shooting it soon.
Tonight I engraved the receiver and chopped the barrel to 12.4". I cut it a little long with a hacksaw, then faced and crowned the barrel in my lathe. The barrel is ~19.5mm in diameter, so it just fit through the 20mm spindle bore. The barrel steel cut easily with a carbide indexable insert while turning at ~450 RPM.
Aside from looking right, it handles a lot better. It's still heavy but the balance is much better without the extra 4.5" of barrel sticking out on the end. I'm looking forward to shooting it soon.