mswestfall
Member
- Joined
- Mar 9, 2006
- Messages
- 437
I had two problems reloading tonight on a Dillion 550B with Lee dies.
1) The bullet OAL are ranging from 2.255 to 2.275. The seating die is tight and they don't get shorter or longer as
2) About half of the Nosler 69 grain Competition Bullets have cuts or scratches in them. There are about 10 parallel lines that are "cut" into the bullet from about 3/16" from the tip of the HPBT and run about 1/4 to 3/8" down the bullet. They are very even.
I don't know if it's the seating die or the FCD. I suspect it's the seating die.
Any ideas?
1) The bullet OAL are ranging from 2.255 to 2.275. The seating die is tight and they don't get shorter or longer as
2) About half of the Nosler 69 grain Competition Bullets have cuts or scratches in them. There are about 10 parallel lines that are "cut" into the bullet from about 3/16" from the tip of the HPBT and run about 1/4 to 3/8" down the bullet. They are very even.
I don't know if it's the seating die or the FCD. I suspect it's the seating die.
Any ideas?