CosmicCowboy
Member
- Joined
- Dec 30, 2018
- Messages
- 5
I just bought a nickel plated Uberti Cattleman II and after firing it for the first time, I noticed the dreaded etched ring halfway around the cylinder. I was careful to go from half-cock to full-cock before lowering the hammer. Could this be due to an out of tuned action or something else? I did pull the cylinder out to clean it and was wondering if when I reinserted it, I inadvertently caused this to happen. Also, is there a way to remove the etched line on a nickel finish without removing too much of the nickel plating or am I stuck with it?