I took the Jordan Trooper stocks off my Security Six this afternoon to thoroughly clean the gun.
When I reassembled the gun, the stock screw would not engage the female portion of the opposite stock enough to tighten down. The stocks appeared to be on the gun properly.
I tried it with the stocks off the gun, and had the same result.
I also tried a different stock screw from another pair of Herrett stocks, and there was no difference.
The brass female portion is not stripped; the screw engages OK when put directly in without the other stock being in the way. For some reason the screw no longer reaches far enough.
Any suggestions?
When I reassembled the gun, the stock screw would not engage the female portion of the opposite stock enough to tighten down. The stocks appeared to be on the gun properly.
I tried it with the stocks off the gun, and had the same result.
I also tried a different stock screw from another pair of Herrett stocks, and there was no difference.
The brass female portion is not stripped; the screw engages OK when put directly in without the other stock being in the way. For some reason the screw no longer reaches far enough.
Any suggestions?