Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Used Taurus 82

Discussion in 'Handguns: Revolvers' started by gfpd707, Mar 24, 2012.

Thread Status:
Not open for further replies.
  1. gfpd707

    gfpd707 Member

    Joined:
    Nov 28, 2009
    Messages:
    253
    Location:
    Illinois
    So I purchased a used Taurus model 82 for $150. The finish was pretty rough but no serious rust. Today I went to the farm store and bought a Birchwood casey home rebluing kit for $18.00. The reblue kit turned out great and wasnt too hard except for the ton of elbow grease I had to invest. So my question is where can i find a set of rubber grips for it? Currently it has the factory rubber Taurus grips with a lanyard ring. I would not have a problem cutting the lanyard off to facilitate the grip install. I have googled for a day and came up with a lot of muddy water.
     
  2. Tomcat47

    Tomcat47 Member

    Joined:
    May 24, 2007
    Messages:
    1,316
    Location:
    South Carolina
  3. MCgunner

    MCgunner Member

    Joined:
    Dec 3, 2005
    Messages:
    25,073
    Location:
    The end of the road between Sodom and Gomorrah Tex
    I have a Hogue on my 3" 66. I like Hogues. But, it might cause problems as it uses a stirrup over the bottom of the grip frame to hold the grip on which might interfere with what ever lanyard ring mounting is on the gun.
     
  4. MCgunner

    MCgunner Member

    Joined:
    Dec 3, 2005
    Messages:
    25,073
    Location:
    The end of the road between Sodom and Gomorrah Tex
    double tap
     
  5. Ala Dan

    Ala Dan Member in memoriam

    Joined:
    Dec 24, 2002
    Messages:
    12,879
    Location:
    Home Of The First Capitol Of The Confederate State
Thread Status:
Not open for further replies.

Share This Page