MSgtUSAF
Member
Walther stainless .380 PPK/S - purchased used.
Hammer cocked; When safety/decocker lever is rotated DOWN to decock the hammer it stops about 1/2 way down and WILL NOT rotate. BUT - if the hammer is thumbed all the way back, then the safety/decocker rotates and every thing worlks.
I disassembled the slide removing the extractor, firing pin and slid out the saftety.
Put the safety back in - same thing.
I turned my attention to the lower parts and when compared to another PPK the lever can easily be depressed with the hammer normally cocked.
Any ideas?
Thanks
Hammer cocked; When safety/decocker lever is rotated DOWN to decock the hammer it stops about 1/2 way down and WILL NOT rotate. BUT - if the hammer is thumbed all the way back, then the safety/decocker rotates and every thing worlks.
I disassembled the slide removing the extractor, firing pin and slid out the saftety.
Put the safety back in - same thing.
I turned my attention to the lower parts and when compared to another PPK the lever can easily be depressed with the hammer normally cocked.
Any ideas?
Thanks