WFT .308 trimmer leaving a wicked burr

[jeeptim]

Yes I am giving the twist.
I have a wft in .223 works really well but this one I have well its a loner and the burr is nasty. I have an rcbs trimm pro with the deburring tool head and a cordless drill attached runs flawless but I'm trimming 1000 cases and with the trimm pro I will be at this a long time.
Any advise on this wft?

 

[119er]

Mine leaves a bigger burr on .308 than it does on .223. Maybe try to cut slower or speed up the tool, or both. I just accepted it and chamfer/beburr my .308 cases. Not really necessary with my .223. I too am interested in others' experience.

 

[slim 67]

I have one in.223 that works good but I did notice they use a cheap junk made in China end mill for a cutter. When i replace mine I'm going to go to MSC and order a good quality mill and I'm thinking that will make a big difference.