Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Which friction stud for my Win 94?

Discussion in 'Gunsmithing and Repairs' started by chadintex, Jan 9, 2013.

Thread Status:
Not open for further replies.
  1. chadintex

    chadintex Member

    Joined:
    Dec 26, 2002
    Messages:
    166
    Location:
    SE OK
    I replaced the link on my 94 and need a new friction stud. I've found a hollow version and non-hollow. My rifle is in the 3 million serial number range. Which stud should I get, or does it matter?

    Thanks
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Is the old friction stud & spring missing in action??

    If it is there, the best thing to do would be to take it out and look at it.

    rc
     
  3. chadintex

    chadintex Member

    Joined:
    Dec 26, 2002
    Messages:
    166
    Location:
    SE OK
    The retaining pin absolutely refuses to come out.
    I went ahead and ordered the non hollow version, spring, and pin.
    Hopefully they will work.

    Thanks
     
  4. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    You just ain't sweet talked it right yet.

    Get a tapered nail set punch that won't bend, and a steel block with a hole in it to support it.

    If they put it in, it will come out.

    rc
     
Thread Status:
Not open for further replies.

Share This Page