I reload .223 (I know - it's cheap but 1) I love to reload 2) I have the time 3) I work up perfect loads for my guns and 4) I love to reload) So anyway, I picked up a bunch of range brass the other day and resized and trimmed it. Resized it in a Dillon FL resizing die. All of it checked out perfectly in a Lyman case gauge except 7 pieces which were marked FC 68. I'm pretty sure this was military brass (I reamed out the primer holes earlier) but why doesn't it fall into the gauge properly? I passed it through the FL die again and it still does not fit the gauge. :banghead: It appears to be a few thousands too high. Any ideas short of throwing it out, which I most likely will. Ideas people?