Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Winchester coyote laminated

Discussion in 'Rifle Country' started by jim in Anchorage, Mar 2, 2009.

Thread Status:
Not open for further replies.
  1. jim in Anchorage

    jim in Anchorage Member

    Joined:
    Feb 28, 2009
    Messages:
    2,535
    I can't get the barreled action out of the stock. Feels like its caught on something. Will rock slightly,but not come out. Any experience?
     
  2. onehitwonder

    onehitwonder Member

    Joined:
    Dec 15, 2007
    Messages:
    112
    Location:
    Central Texas
    someone might have done a bedding job on it. Makes it very hard to remove stock sometimes. try to lightly tap the action with a rubber mallet while someone pulls the action out of the stock.
     
  3. Auburn1992

    Auburn1992 Member

    Joined:
    Mar 22, 2008
    Messages:
    1,015
    Location:
    Tennessee
    Alright, may sound stupid, but are you sure you've got all the action screws and all out?

    If so, I'll second that rubber mallet.
     
  4. jim in Anchorage

    jim in Anchorage Member

    Joined:
    Feb 28, 2009
    Messages:
    2,535
    I bought it new. And it feels loose enough I am sure all the screws are out. It does feel like separating a glass job,but again I am the original owner.
     
  5. Auburn1992

    Auburn1992 Member

    Joined:
    Mar 22, 2008
    Messages:
    1,015
    Location:
    Tennessee
    It's probably that the stock is just too tight.
     
  6. jim in Anchorage

    jim in Anchorage Member

    Joined:
    Feb 28, 2009
    Messages:
    2,535
    Got it! Just had to get the nerve up to hit a little harder. Sure enough. factory glass bedding. The trigger looks to be normal M 70 adjustments so maybe I can do something about that 100 lb trigger pull.
     
Thread Status:
Not open for further replies.

Share This Page