Being a fairly frugal guy that likes bang for the buck I picked up a couple of M88As recently when they went on sale at several on line "wholesalers" for under $200.
Both functioned fine with 115g Lawman FMJ but after less than 50 rounds each of the pins that hold the extractors in place starting to walk out. Any one else experienced this? Any recommendations for a solution? My first thought was to tap them back in and then put a little drop of green lock tight on the head of the pin and let it seep down and lock them in place. Any one see any potential problems with trying this solution? .....or should I put a little blue LT on then drive them back in place? Thanks in advance for any advice.
Both functioned fine with 115g Lawman FMJ but after less than 50 rounds each of the pins that hold the extractors in place starting to walk out. Any one else experienced this? Any recommendations for a solution? My first thought was to tap them back in and then put a little drop of green lock tight on the head of the pin and let it seep down and lock them in place. Any one see any potential problems with trying this solution? .....or should I put a little blue LT on then drive them back in place? Thanks in advance for any advice.
Last edited: