someguy2800
Member
Last year I decided to add a pistol range off to the side of my rifle range so I kept a section mowed off to the side. I cut the target plates out of 1/4” mild steel with the plasma torch last year, but never got around to making posts to hang them on. The posts just have j hooks welded on them made out of 1/2” threaded rod I had laying around.
The big plates are 8” and the smaller ones about 4”. The closest ones are 10 yards from the front of the bench and the back ones are 28 yards.
I drove the posts in at an angle so the plates have room to swing a bit. Otherwise its hard to tell you hit them. Still plenty of room to mow around them
Next I need to make some more plates. I want to make a couple 50% sized silhouettes, mabey get some AR500 animal silhouettes to set on the ground, and also get a few AR500 hangers so I can use the AR15 on them too.
The big plates are 8” and the smaller ones about 4”. The closest ones are 10 yards from the front of the bench and the back ones are 28 yards.
I drove the posts in at an angle so the plates have room to swing a bit. Otherwise its hard to tell you hit them. Still plenty of room to mow around them
Next I need to make some more plates. I want to make a couple 50% sized silhouettes, mabey get some AR500 animal silhouettes to set on the ground, and also get a few AR500 hangers so I can use the AR15 on them too.
Last edited: