Hockey7711
Member
- Joined
- Nov 15, 2020
- Messages
- 249
Took my Model 65 to the range yesterday...
Went to load it with 357 magnum rounds, and here is where it gets odd...
The same cartridge will fit in some cylinders, but not others. (gun is clean)
At first I thought the COL was too long, so I checked and the were all as they were supposed to be.
So I fired a few rounds and went to open the revolver to eject the shells, and the whole cylinder got jammed. It was stuck open, and had gone too far backwards, overrunning the cylinder stop notch on the side of the frame. It's like the stem had extended itself too far.
Any ideas what is going on?
Went to load it with 357 magnum rounds, and here is where it gets odd...
The same cartridge will fit in some cylinders, but not others. (gun is clean)
At first I thought the COL was too long, so I checked and the were all as they were supposed to be.
So I fired a few rounds and went to open the revolver to eject the shells, and the whole cylinder got jammed. It was stuck open, and had gone too far backwards, overrunning the cylinder stop notch on the side of the frame. It's like the stem had extended itself too far.
Any ideas what is going on?