letsbuildasnowman
Member
- Joined
- Dec 23, 2012
- Messages
- 10
Yesterday I picked up a brand new I.O. Hellcat from my FFL. I loaded up the magazine and tried to chamber a round with no luck. Would either not chamber at all or sometimes it would half way. Went out bought different ammo still same issue.
I took it apart and noticed the entire barrel was pitted. I also noticed the feed ramp was clearly not finished and cut short. I do not know how they even test fired this gun. I have left a message with I.O. and emailed them these photos. No contact with anyone due to the holidays but I will be sure to report back on the customer service. The gun has a warranty. It blows my mind how the gun went out of their doors like this. Here are my pictures and on the bottom with it should look like. Not here to make anyone look bad at this point just passing this along and again will report back on how this gets resolved.
and here is what is it supposed to look like
I took it apart and noticed the entire barrel was pitted. I also noticed the feed ramp was clearly not finished and cut short. I do not know how they even test fired this gun. I have left a message with I.O. and emailed them these photos. No contact with anyone due to the holidays but I will be sure to report back on the customer service. The gun has a warranty. It blows my mind how the gun went out of their doors like this. Here are my pictures and on the bottom with it should look like. Not here to make anyone look bad at this point just passing this along and again will report back on how this gets resolved.
and here is what is it supposed to look like