bengals1975
Member
- Joined
- Jan 23, 2013
- Messages
- 32
So I'm new to reloading and as such I made a good amount of dummy rounds to set up my dies, get familiar with my press and how it works, test OAL, etc.
Now that I'm happy with my setup, I don't need the dummy rounds. I ordered a bullet puller so when it shows up I'm going to pull them apart but how should I treat the brass? What I mean is, since I was using new brass, should I treat it as once fired now or does the shaping/stretching not impact the case life that way? It seems like it would but I wasn't sure.
I'm tracking the usage of my cases as recommended by my manual and I'm not what category to put these in.
Thanks!
Now that I'm happy with my setup, I don't need the dummy rounds. I ordered a bullet puller so when it shows up I'm going to pull them apart but how should I treat the brass? What I mean is, since I was using new brass, should I treat it as once fired now or does the shaping/stretching not impact the case life that way? It seems like it would but I wasn't sure.
I'm tracking the usage of my cases as recommended by my manual and I'm not what category to put these in.
Thanks!