Reddyeddy:I wish I didn't get ... the powder measure. These were just mistakes on my part. Didn't know/realize that ... there's no real way to use a powder measure with a hand press.
If you batch load your powder into cases using the loading block you can fill cases quickly and then check...
Hornady
Dentite,
I have only one Hornady die set but that ring is great. I also long ago replaced some but not all RCBS and Redding lock rings with Lee. Don't laugh; if used carefully they are useful but yes, they can slip. I have some unused extra Forster ones I may employ until I can...
I read Gamestalker's answer too quickly and misinterpreted his response. My brass does close on the bolt but it has not been sized in any capacity and I thought he meant I did not have to size. I'll reset (check my FL die) and size all of the brass. Then I'll check trim to length (again as...
Thank you, both. The wood slat worked just fine. All of the 30 pieces fit the chamber except 3 (which really did close but were a tiny bit tight so I resized them). If I do not need to size the 27 pieces, don't I need to neck size these as I usually do after firing?
Probably the dummest questions ever asked, but what can I say?
1. Have full length die set per instructions from 14 years ago. It is a Redding die which came with a lead shot to lock the lock ring in place. I want to attempt just a bump set back but I can't move the lock ring/die. How does...
GW,
The second Sunday of every month, rain or shine, holiday or not, we shoot at range 5 at Chabot. BP only. Relaxed, informal. Everyone helps everyone especially newcomers. PM me for more info. bronsht
schematic
Jackal: I have that schematic in my owner's manual. Not being the brightest mechanical booger in the group, I thought I ask the experienced members, how one actually takes out the spring/plunger/extractor and how to reinstall in case there are tricks I should know. Any ideas or do...
buckmark extraction
Thank you, rbernie. I never dry fire-was told that I would break the firing pin. I'll dry it out. bronsht. If I need to replace the parts, can anyone advise me of takedown? bronsht
Hello. bronsht here; new member. Could any of you help me? Have a buckmark target pistol. Haven't used it in a while. It is not extracting spent brass. I oiled it up, but it didn't help. Did a standard take down and cleaning, then oiled it up. Still does not work. Do I need to replace...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.