Recent content by CoconutMilk

Gents, So here are my questions: And below that is all my data and setup. 1. Is the discoloration on the brass from low pressure, high pressure or is it meaningless? Picture should be attached. 2. On the taper crimp, how can I tell if it is crimped right? too little/too much? I am...

All, I have just completed setting up my first press, a Hornady LNL AP Ammo Plant, complete with case feeder and bullet feeder. Dies setup as follows: Station 1- RCBS size and deprimer Station 2- Hornady PTX Expander/powder drop Station 3- Hornady Powder COP Station 4- Hornady Bullet Feeder Die...

9mm plinking reloads (NEWBIE) All, I have just completed setting up my first press, a Hornady LNL AP Ammo Plant, complete with case feeder and bullet feeder. Dies setup as follows: Station 1- RCBS size and deprimer Station 2- Hornady PTX Expander/powder drop Station 3- Hornady Powder COP...

All, I have just completed setting up my first press, a Hornady LNL AP Ammo Plant, complete with case feeder and bullet feeder. Dies setup as follows: Station 1- RCBS size and deprimer Station 2- Hornady PTX Expander/powder drop Station 3- Hornady Powder COP Station 4- Hornady Bullet Feeder Die...

9mm Plinking Recipe (newbie) All, I have just completed setting up my first press, a Hornady LNL AP Ammo Plant, complete with case feeder and bullet feeder. Dies setup as follows: Station 1- RCBS size and deprimer Station 2- Hornady PTX Expander/powder drop Station 3- Hornady Powder COP...

bob, thanks for the info on powdervalley. I will look into that for my next order. Wobbly, thanks for clearing that up for me. I was always under the impression of trying to find the same brnad name in the manual, which is where the confusion was comming from on the MG rounds. Thank you all...

Thankyou all for the info!

Thank you all for your input. 1SOW I have plenty of manuals, problem is, I can't find any hard data on the Montana Gold 115gr FMJ. Which is why I was asking for everyone's opinion on a good start point for this round. Again, thanks for all your thoughts and advice.

Correction to my last post. What would be a good starting cartridge overall length? Max and min COL?

Thank you for that information. I am looking at some Unique now. I have a few manuals and came to the same conclusion as you on the powder charge. I am still not sure on the Overall length though, any ideas on a max and min OAL?

Hi group, newbie here and needing help. I am new to reloading and have some questions on a load or components of a load I would like to use. I currently shoot approx 10k rounds from a Glock 19 every month. Ammo is pricey though and I am looking to save on my shooting. Below are the components...