Recent content by dshowan

For paper punching I agree with bfoosh. But my 300wm A-bolt just likes 165gr. the best. I shot a 1 1/2" group today at 300yds with 165 accubonds.

Here are my benches on a bad day. Fertile minds thrive in apparent chaos

RL22 with about 75-76 gr. would be a good place to start.

Those pictures are taken to make the keltec look bigger. Put the keltec in the back and see how it looks. Also, in the picture with the top view, the keltec is angled to make it look wider. Not quite a fair comparison, but who took the pictures???

I'd rather deal with a company that didn't put a lifetime warranty in writing and took good care of you if you have a problem, than a company that offers a lifetime warranty and is a pain to deal with or goes out of business. By the way - My M&P9c is a great gun.

The S&W web site manual is the same as mine. I posted the following over at the M&P forum also. Here are my emails to and from S&W: Hello, I just purchased a M&P 9c pistol. One of the reasons I chose it was because of the lifetime warranty I had heard about. The lifetime warranty is...

It's not in my manual for the gun I bought last week. I hope they didn't change the warranty.

Did you see that in a compact manual? I read the warranty section again and it does have anything about a extended service policy. ??????

One reason I recently bought a M&P 9c was the lifetime warranty I read about (many places have said this). The back of of my manual says 1 year. I'm going to e-mail S&W but their web sight is down right now. Does anyone know the story on this?

Most accutate medium load seems to be 27.0 gr. with the 250xtp's. Consistant 3/4"-1" groups @ 60yd. approx 1400fps. with my Ruger SRH 1.5-4 Burris scope. Not bad.

No speed numbers yet, the weather here has been lousy. Hopefully this weekend.

250xtp, 26g lil gun, 1 1/2" - 3 shot group @ 60yd. Seems like a good start.

I just bought some lil' gun for full power loads and tite group so that's why I asked about those. I think I'll try some 2400 and tite group. My goal is great accuracy @ around 1300-1400fps for whitetail hunting. Thanks

I noticed that Sierra lists a load for 240g. JHC bullets using Lil'gun down to 19g. @ 1100fps. And 26.2g. @1400fps. Anyone load Lil'gun down that low in a 454? I'm looking for a good powder for around 1300-1400fps. I'm also considering tite group. With 11g. it should give about 1300fps.

I'm sure others will disagree but I'm convinced that the old fashioned beam scales are much more accurate. When trickle weighing with the 5-0-5 you can get repeatable accuracy down to 1 fleck/piece of powder if you are very careful and take your time. I have a electronic scale also and when...