I do not have much cast up right now, but I do have a few that might fit what you are after, at least enough to test and see if you want to pursue it. I do not have any .360 158g cast up right now since I have mostly been using the NOE 180 for all my .357 shooting.
https://www.midwayusa.com/product/1...e-38-s-and-w-358-diameter-158-grain-flat-nose
Got some of these in .359 cast up in WW/scrap. No lube, unzized as from mold.
http://noebulletmolds.com/NV/produc...cts_id=1332&osCsid=6do8h6r0i0n7ocajhovrs26ud3
Also have some of these done in ww/scrap. They measure at .360. 2 varieties here.
177g w/ hollow point, lube and gas check, Have some without lube and check too.
187g w/ Wide flat nose, powdercoat and gas check, have some without PC and check too.
The Lee 158 weighs out at about 160g and does not cast at nice as the NOE. BUT it does plenty well enough in my carbines and revolvers. I generally tumble lube in ALOX, though powder coat works too.
The NOE mold does very well from my carbines and revolvers. It does fine at full h110 loadings as well as lower power 1000 FPS carbine loads. The hollow pointed bullet is the one that usually gets revolver duty. No issues there at low or full power loads in my guns.
The 180s are heavier than I used to use, but I bought it as a carbine mold and it shot well enough in all my guns that I generally dont bother to cast up any others.
Shoot me a PM if you would like to discuss it further!