SC_Dave
Member
I hope I can make this understandable. Long time issue with 9mm.
1 in 10-15 cases will not decap. Meaning the primer will not push completely free of the case and drop away. So it prevents shell plate from rotating on my LnL AP because the primer is only partially out and is binding the ram plate. The Sizing/Decapping die is RCBS. I have adjusted the pin as far down as I safely can without the collar that holds the pin protruding below the bottom of the die.
The cases are not crimped and are not the same manufacturer. I have also eliminated the possibility that the pin is being pushed up by the case.
Anyone have this issue before? Thanks in advance for your help.
David
1 in 10-15 cases will not decap. Meaning the primer will not push completely free of the case and drop away. So it prevents shell plate from rotating on my LnL AP because the primer is only partially out and is binding the ram plate. The Sizing/Decapping die is RCBS. I have adjusted the pin as far down as I safely can without the collar that holds the pin protruding below the bottom of the die.
The cases are not crimped and are not the same manufacturer. I have also eliminated the possibility that the pin is being pushed up by the case.
Anyone have this issue before? Thanks in advance for your help.
David