Seems as though if I lower the sizing die as far as possible (and then some as well), it still doesn't bump the shoulder enough. Using the stoney point tool, I might be able to squeeze .001 out of it, but the instructions recommend at least .002 (as high as .004 for semi-auto, which is the case here). I also have a LNL single stage and I can get it to work on that, but it looks like it actually contacts the die as it cams over. This is using an RCBS shellholder as well, maybe the redding is a little lower.
Does anyone have a set of dies that they've used succesfully in the LNL AP for .223? If so, are you absolutely sure it is bumping the shoulder enough? Also, do you have room to spare, or is it actually touching the shell plate?
Does anyone have a set of dies that they've used succesfully in the LNL AP for .223? If so, are you absolutely sure it is bumping the shoulder enough? Also, do you have room to spare, or is it actually touching the shell plate?