You can get it there, or Dick's, or Walmart...basically anywhere they sell anything related to firearms. You will need a 5/32 and 7/32 drill bit, and then wrap electrical tape around the bits at the length specified on the package and install the stud.
Measure about 3" from the toe of the stock, cover with masking tape ans drill a hole 90 degrees to the stock a tad longer than the screw. Use a bar of soap on the threads to act as a lube then turn in to the hole - after removing the masking tape.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.