fireman
Member
Happy Thanksgiving,
I have a 7600 Remington in 30-06.
I took an old Leopold 4x12 off a very accurate target rifle and attempted to mount it on my new 7600. it shot 10 feet low at 100 yards.
I took off the Remington base and calipered it (#92 I believe) and I had .102 on each end. I swapped out the weaver rings- same result- tried a different scope same result. Shimmed base .040 in the rear and then was only about 5 feet low. I'm thinking of returning it to the factory for exchange but want to ask you guys if you think I have missed anything? Could my receiver be out that much on a new rifle?
Maybe they just do not make them like they used to.
Thanks
Fireman
I have a 7600 Remington in 30-06.
I took an old Leopold 4x12 off a very accurate target rifle and attempted to mount it on my new 7600. it shot 10 feet low at 100 yards.
I took off the Remington base and calipered it (#92 I believe) and I had .102 on each end. I swapped out the weaver rings- same result- tried a different scope same result. Shimmed base .040 in the rear and then was only about 5 feet low. I'm thinking of returning it to the factory for exchange but want to ask you guys if you think I have missed anything? Could my receiver be out that much on a new rifle?
Maybe they just do not make them like they used to.
Thanks
Fireman