Search results for query: *

I bought a CMMG .22 conversion for my M-4/AR-15 but had to return it. The bolt would not return to the forward position. Took a look at it with the guy at the gunshop, and we could see that my hammer sat too high to allow the bolt to move freely. He offered to sell me a new "trigger" which...

Feed and extract seem OK, but about 30% of shots the trigger pull does not cause anything to happen. Pulling the bolt handle back an inch or so seems to reset it, so I can take a shot without feeding a new round into the chamber. I have cleaned it pretty well, I think. I have tried a...

Please help! Strange mechanical issue with Marlin Glenfield. I found a used Marlin Model 60, and I'm almost happy with it. Feeds & ejects fine, but about 30% of the time the trigger does not reset or the striker does not cock (not sure which describes it better). With a round in chamber, I...

I've just started getting into rifle after years of handgun shooting, an was looking at old (1940's) Army marksmanship films. I realized the keys to rifle shooting are posture/position and breathing, which equate to Yoga's Asana and Prana. Even the relaxation and heartbeat control in Yoga are...

I want an official Red Ryder carbine action two-hundred shot range model air rifle with a compass in the stock and this thing that tells time! OK, not really, but I have been looking for an old Marlin Glenfield Model 60 with 18 round mag tube and a squirrel on the stock. Finally found...

Anyone know where I can buy firefly sights, and if they're worth using? Are they adjustable for elevation?

Help! - "Extra" hole in receiver of gas-operated semi? I inherited a Beretta semi-auto trap gun, but have not fired it yet. There appears to be an "extra" hole in the left side of the receiver similar to the other ones which have pins or screws in them. Is this just a vent or something...

I plan to start with a .22 rifle, probably a Marlin Model 60 or Ruger 10/22. Any suggestions? If there is a thread on this already, please point me in the right direction. Searching on ".22 rifle" got me nowhere. I plan to add a Dragunov stock, etc., so availability of accessories is...

I just got my dad's old Golden Lark Semi-auto Beretta 12ga, and I'm anxious to give it a try. But I really don't know Beretta shotguns, and I'm worried about one thing - there is a hole in the receiver! It looks just like the other receiver holes, with the decoration around it, but all the...

So for Fathers Day I cleaned all of my dad's guns. Dug deep into the safe, and even cleaned stuff he hadn't shot in years. So he gives me one! :what: A Beretta Golden Lark, 12ga semi-auto trap gun. Nice Fathers Day gift from dad. But I can't find any information on it anywhere! I plan...

Is there a chart that compares size and weight for a variety of snubby revolvers? I'm looking for something similar to Bobo's pocket auto comparison chart but for wheelguns.

I got a used SP101 in .22 for some low-cost plinking. But I can shoot better with my .357 snub than this .22 with a 4" barrel. I got a pretty good shooter to try it out for me off a sandbag, and he got a 3" group at 15 yards. Should I expect better?

I just installed a Tacstar sidesaddle on my Mossberg 590, and I have an unusual problem. On the next to last shell, nothing happens when I pull the trigger! Action seems to cycle the same on all shells. I've heard the warnings about overtightening the screw, but I've tried it with different...

Anyone know where or even if I can get a Marinecote barrel for my Mossberg 590 that is choked or will accept screw-in chokes? I feel like I've looked everywhere already, so please, any suggestions welcome.

Anyone familiar with a revolver with Manufacturer or Model name "Marley?" Archie Goodwin is supposed to carry one in the Nero Wolfe detective stories, but I have found no info so far.

Mysterious samurai saves Police in UK Tue 10:50pm A samurai sword wielding vigilante has come to the rescue of two Police officers when they were attacked by an armed gang in South Shields, England. A group of men had forced their way into a house and were ransacking the place when...

I'm looking for a pocket holster for my SP-101 snubby. Is anyone familiar with the safariland model 25? It looks good, but is more closely shaped to the gun than a lot of other pocket holsters I've seen. Has anyone used one? Does it stay in place in a pocket?

Are GLOCK strikers (firing pin) compatable between different models and calibers? I have a .40 model 35, and a chance to pick up some cheap that were removed from 9mm models 17 and 19.

I want to get my Glock 35 ready to shoot Limited class. I'm looking at ICE and THE magwells, and Dillon, THE, and Arredondo basepads. What works well? Is there a thread on this already? I haven't found one.

Has anyone seen this? I thought the Glock keylocks were in the base of the grip. I was trying to remove the plate on the rear of the slide so I could replace the striker spring, but there was a keyhole in the middle of the plate, and I had trouble removing it. I have done this before to other...