Search results for query: *

I bought a box and shot them from a 4" gp100 and they are hot.shot really high compared to my 158 grn swc and 2400 load that gun sighted in for.did not feel i could be very accurate with them.so decided better carry a load that im comfortable and familliar with for field carry.Jim

if you are seating and crimping in same step i bet that is your problem.as you are pushing bullet into case and squeezing[crimping] neck you are buckling case is my guess.i load on a single stage also and like the ability to feel how much crimp is being applied.separate seat and crimp steps and...

No one has really mentioned that his recipe is a poor one on a few accounts.if he would have assembled the same load with a fast powder they would have all gone off.loads need to have a balance in components.hence the powder he is using is for full magnum loads.the bullets are low velocity...

rather than pull them set aside until you do a work up of the powder bullet combo.your loads might be safe and easier to shoot them pull them.your workup will will give you good idea if loads are good to go or hot.JIMBOB123

13grns 2400 with that bullet is my go to load in 357.very accurate and absolutely no leading.Never used titegroup but have read others comment that it leaves a yellowish coating on outside of gun after shooting which all powders do but some more than others.also heard that titegroup burns hotter...

Josh sounds to me you are putting to much crimp on them.berrys bullets dont have a canalure like jacketed or a crimp groove like a lead bullet.to crimp on a copper bullet without a canalure you need to remove the bell from the case and force the case against the bullet to hold it tight but you...

Yeah i bought some for my 12ga for hunting loads and did not like herco.So i loaded some up for my 41mag and first ones shot better than my unique loads i have been loading.Have not been back to range with more to try yet.Not sure why alliant does not promote it more than they do as a pistol...

I bought some 180 xtp the other day and loaded them with 13.5 h110 with a cci 550 primer.Shot a couple the other day in my gp100 and they seem fine.No signs of being over pressure.There are two crimp grooves in the bullet so i went by the length called for for the nosler .that put length into...

Duck911yeh i bought a sample pack of the strickers with my last order.Loaded 5 with 12.5 grns h110 and mag primer in 357 case and shot off rest at 25yds.1.25 inch group not kidding.excited about loading more to see if it was a fluke.dont think so.Missouri bullets are good.This was shot out of a...