Search results for query: *

Trying to get the barrel off of my springfield receiver. Is it pinned??

Got a couple of boxes of Canadian Imperial 303 British brass from a friend down in Fla. Neck sized and trimmed this evening and getting ready to reload. Any heads-up for me on this brass? Looking forward to seeing how it shoots. I have some PPU and Winchester that I have worked on also...

I had an out of battery detonation last month. I was firing 7.61 NATO reloads in my M1A. When it went off there was a distinctively lower toned bang, lots of blue smoke, stiff wind on my hand and face, and the bottom of the mag flew off. My determination is that I let an improperly seated...

Does anyone know where to get some replacement screws for the SA scope mount for the M1A? I need the longer rear screw as I have broken two of them in the last couple of years and have forgotten where I got them. I don't see them listed on Fulton Armory site anymore and the SA site is so effin...

I finally got out to the range today to check out some of my reloads. I was trying out some 4064, H4831SC, Varget, and 4320 powders that were in some boxer primed commercial reloads and some berdan primed POF brass that I had dissassembled and replaced the powder and projectile. I only used...

I am finding out there isn't any MRP at the few suppliers that do carry it. Does anyone have a clue when it is coming back to the good ol' USA. I have not contacted, or tried to contact, Norma to find out any info. Others have said they will have this discussion at the ShotShow early next...

I have been working on some loads for a 44mag Ruger lately and had some failure to fire today. I looked and looked and found that I had tightened the screw on my grips a little too much. The screw apparently is turned with different diameters to accomodate movement of the long bar on the...

A friend has a SW 657 he want to sell. What does it go for? He says he paid $650 back in 1986.

A friend has a S&W 657 in 9mm for sale. Usual "low rouund count", "take it out maybe once a year". Stainless steel,. Where does this thing sit in the ballpark of $$?

Does anybody know where I can get some firing pins for an 1880ca, LC Smith Maker, 10ga, hammerless, side by side?

Does anyone out there reload this cartridge? Cheap milsurp is disappearing and I am considering reloading (if there is any brass out there).

I just put together two rifles in 6.5x55 Swedish Mauser. Adams & Bennet barrels on sale for $89.99. I hand finished the chambers with a PTG chamber finishing bit to acceptable tolerances using appropriate GO NOGO gauges. I am using Norma brass in both of the rifles and during load development...

I would like to find some shells and firing pins for this old 10ga LC Smith that I got onto a few years ago. Damascus twist steel from about 1888 according to some input from an LC Smith collectors site. Hammerless model. Anyone got any info?