Search results for query: *

Our daily bag limit for dove went from 10 dove with no more than 6 white wings to 15 with no more than 10 white wings in the aggregate. I was so excited I had to go out and buy a new shotgun to replace my ol' Wingmaster. I think it has been a long time coming since this place is absolutely...

I just got three buckets of wheel weights and other tire shop trash and I was looking for some 411 from the casting crew. I went to the site twice and I get redirected to other "similar"sites. FWW, I was wondering if the AL, MC, AL-MC on the lead weights indicate anything about the alloys used...

I have never loaded belted brass before, just -06 and handgun. My question is weather or not to full-length size or just neck size the brass. It will be fired in the same rifle it was fire-sized in. I want to measure for a good c.o.l. so I'm kinda leaning towards neck sizing only. Thoughts...

After reading Splattergun's post, I thought maybe we oughtta turn our attention to our faithful hunting companions, the dog. Here's my clod, Rosco. He's a decent dove fetcher and he loves the water. I don't think I'll ever instill enough discipline into him to be a good duck dog, but he still...

Now that I have a shotgun that I can change the choke tube in, I figured I'de ask about and see what y'all use for wingshooting. My 870 came with a MOD installed and I really don't have plans on changing that unless I get some different asdvice.

I dug out my steel framed 1841 .44 and I might take it to the range and fire off some round balls. Unfortunately all I have is Elephant brand FFg black powder that I use in my .50 cal percussion Hawken. What would be the outcome of firing this powder? I'm assuming it would just make a longer...

My fairly new RCBS FL .25-06 dies are beginning to show signs of rust. Theres a tad bit on the top and some speckling around the brand / caliber stamp on the side. I looked at the resizing ball and it was spotted as well. I have kept my dies on top of my safe, in a closet, in an air-conditioned...

It's 2200 here in Az and it's 105 degrees in my garage so instead of doing any reloading tasks, I decided to look at this bag of Magtech .357 brass I just bought the other day. I measured one case and it came out to be 1.280 which is the trim length according to Hornady 8th. Max is 1.290 so...

Or does it even matter? I've never loaded this cartridge, in fact I haven't even gone to the store for the dies yet, but my Hornady 8th ed. shows two different dia. at different grains. 110 gr is .308 123 gr is .310 130 gr is .308 150-155 gr is .308 I was planning on going with a 110...

I have a fairly new Lyman twin. I have only used the large bowl up to now and it is filthy. I kinda had the thought of getting at least one more bowl to tumble clean, sized brass and loaded rounds while using my current dirty bowl and media for post-fired brass only. Does anyone with the twin...

My wife worked the last three nights (7-7), and today she admitted that she didn't get me anything for Father's Day and therefore, I can get my membership at the local Rio Salado Sportsman's Club or my RCBS Uniflow powder measure that I had on my wish list. I don't really need a membership...

What are your thoughts on the RCBS Uniflow powder measure? http://www.basspro.com/RCBS-Uniflow-Powder-Measure/product/10207301/44102 Right now i have an old Lyman with a slide and it doesn't drop rifle powder consistently. I have to tap the handle at the top to get the powder to settle into...