Search results for query: *

My dad gets the American Rifleman and I usually end up with them after he is done. I've noticed in the evaluations of new guns that the 100 yard groups seem pretty loose on the average. Even with reputable makers, a lot of these groups with the .308 are upwards of 1.5"...I'm no sniper or...

Went looking for a .300WM today, couldn't find the 700P I was looking for and after rejecting a 7mag model 770(the bolt was gritty and rough and not what I would expect in a Rem) I ordered up a 700VLS in .308 Win. Next step is the glass. I want to make this a long range rifle, and want something...

How good are Magpul's drop in tactical stocks for the Model 700? Wanted to go with the McMillan A4, but after adding all the things like pillars, cheek-piece, and butt-pad it will cost more than the rifle I plan to use it on. The Magpul has those features on it and is significantly less...

I am looking to purchase a model 700 next fall after the construction season and would like something with a 26" heavy barrel for long range shooting, bench as well as field, but can't decide whether to go .308 or .300 Win-mag. I have a short-barreled .308 and a 7.62x54R already and have always...

Is anyone out there using the Atlatl? I have been dabbling with them and have made several, it's actually not bad exercise and a fun little hobby when you actually hit what you are throwing at, in my case about one in every thirty throws or so...

I recently picked up a Remington model 600 Mohawk in .308 and after a little tune-up I am pretty happy with it. I ditched the Tasco scope someone had put on it and replaced it with a Redfield wide-angle 3X9 I had languishing in my gun cabinet, pulled the open sights(can't use 'em anymore...

I own a Romanian PSL rifle and have read that you shouldn't use more than a 148g slug in them as heavier slugs tend to beat the receiver up...so far, the only factory load I've found is from Hornady and it was 168g or something like that...can you use any 7.62 slug to hand-load this round? Is...

I recently saw some posts on another site where someone asked whether or not you should clean the gas tube on an AR-15...some years ago, someone told me that keeping it clean was a must, but many replies to the guy's question were that it is not necessary...is this true? I've only put about...

I bought a Romanian PSL awhile back and found it to plagued with feed problems. After taking my Dremel to various parts of the action, bolt, and magazine, I now have it working, still gotta short-load the ten round mag to six though. It's big,ugly, and scary- I really like it! Just wondering if...

I bought an American Arms Escort .380 for two hundred bucks a couple of years back and have found it to be a decent shooter and light-weight, well balanced, and well-made except for the rubber grips. They only have one screw which is located close to one edge of the grip, not providing the best...