I scored an I.N.A. 32 revolver for $150 at the last gun show. It is a Brazilian clone of the Smith model 30/31. It has like a 300 lb trigger pull. Ordered a spring kit to install and will Polish the pertinent internals. Hopefully that solves the problem.
Sent from my SM-G530T using Tapatalk
I have a 1st Gen P32 that I acquired a couple months ago. Small enough to conceal in any clothing... I am convinced a stripper could conceal one in her string bikini during a pole dance... it goes bang every time... and recoil is surprisingly pleasant.
Sent from my SM-G530T using Tapatalk
Well, one of my questions was "is this normal". Been in the gun and shooting hobby many years. This is my first foray into polymer.
Sent from my SM-G530T using Tapatalk
Thanks
I just got the p32 this week and haven't taken it to the range yet.
It's a low serial number gen 1, so I imagine it has seen a round or two.
Sent from my SM-G530T using Tapatalk
Bought a used kel tec p32. The magazine inserts all the way flush with the bottom of the grip, but after I insert it the mag is pushed back as if a release spring is pushing it back. The mag release holds the mag in place, but there is about a 1/8 or so inch gap between the mag plate and bottom...
The one on the left is a 6906. On the right is a 5906. Should be able to find mags for them at a gun show fairly easily. The 5906 mag will fit the 6906 but will stick out the bottom. The mag for the 6906 is too short for the 5906.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.