Search results for query: *

  • Users: Claus
  • Content: Threads
  • Order by date
  1. C

    Suppressor private sale?

    I’m looking for a quick overview of the legal requirements to purchase a suppressor from a private individual, does anyone have some input? In particular, a private FTF sale instead of buying new from a dealer who would file all of the necessary paperwork. (disclaimer- yes I know that I...
  2. C

    CCI Quiet-22 ?

    Seem to remember buying some of these because that’s all there was during the last shortage. Didn’t cycle my pistol but shot ok, eased the withdrawal a bit. Now again I see them available when little else is on the shelves. Anybody have any opinions on these? They say don’t use in a rifle...
  3. C

    Alternative to Walmart for ammo purchase?

    Yeah I’m kinda bummed by their new policy. I’ve been buying Federal 9mm (brass, 115gr) 200 rounds for $33 and change. To me it was plinking/range ammo cheap enough that I never bothered to reload 9mm and it was nice to go and shoot and not go grubbing around after all the spent cases. It was...
  4. C

    S&B/Herters cases tight primer fix

    When I started reloading a little over a year ago I picked up several hundred Herters 38 spl rounds to start saving the brass. After lots of stumbles, smashed primers and aggravation I learned from this list that these brands (Cabela's Herter boxes say they're loaded by S&B) tend to have tight...
  5. C

    380 primers slightly raised - problem?

    Finally got the pro 1000 into the groove and cranked out a few hundred 380 ACP's. Upon inspection I notice a couple of dozen that don't sit flat, or just slightly wobble. Not enough to feel or see without magnification but the primers are seated just quite not all the way. I know now that I...
  6. C

    Lighter bullets??

    I've been reloading for only a few months, pretty much trying to load close to factory loads or maybe a bit lighter recoil. I'm looking for target loads. My primary reason at this point is to shoot cheaper. I've been loading 38 special and just getting ready to dip into 45 ACP. I see a lot...
  7. C

    Measuring light loads for 380

    Hello - My first post, thank you all for the huge amount I've learned reading this forum so far. I'm loading 100gr Berry's plated RN with Bullseye. I have a Lee pro 1000 with the auto disk powder measure. Since it bottoms out at ~2.8 gr of Bullseye I'm looking for a way to load lighter...
Back
Top