2'' or better 25yrd groups out of a Smith 357 is common at least fom a rest. But what can a comp grade semi like the Elite do at 25yrds. I've found them in 9mm,40 and 45 and don't know which caliber would be the most accurate. I was told they were not carry guns just competion.
I need a little help on finding info on the 410 WW paper hulls. All I've found so far is an old Texan manual. It list 1/2 oz with 15 grs of 2400. No mention of wads, brand of cases or primers. It does say reduce 10% for plastic wads.
Thanks
Can you make a handgun from the ground up legally. If so can use a cut down rifle barrel . Boredoom is a bad thing around guns. You either trade off a good one or sporterize the wrong one. Thanks.
I've just read Clarks reply on 98 bolts heat teament. I was wondering which country builds the best and the worst 98. Most books rate the pre WW2 Arisaka at #1 .The German vk98,and some kind of cast iron last ditch Arisaka as worse. Early Springfields 03 had brittle recievers. The p14,17...
Seen a really nice Mossy 5500 last yr and to make a long story short I walked in with a 870 and walked out with the Mossy. The bolt didn't allways stay open but after a half box of shells the pin fell out that holds the shell stop. No problems worked fine after epoxing the pin back. Loaned it to...
A while back I posted a thread on air guns. I really appreciated the advice and input. I finally got a crossman 2240 co2 pistol. After spending 50 bucks on gas looking for one in Lubbock.No telling how much I spent on phone calls to Amarillo I ended up ordering online thru www...
It's been a tough winter on the high plains of Texas. Sold most of my guns now time to buy back. So the question is are any of the Big 5, Academy or wallymart pellet guns worth buying or am I better off with a slingshot. All the stuff I read on the internet says its all junk unless it has a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.