I was looking at purchasing an expander die and mandrel from Sinclair to remove the dents and dings I find on some new cases.
If I use this coupled with full length sizing... should I remove the expander ball from the decapping rod and just rely on the mandrel for forming the case neck...
I would like to find an acceptable powder charge (or charge range) using H4831 with 150 grain bullets.
I know H4831 is a slow burning powder and not a good choice for pushing bullets this light. I use this powder for 180 grainers. My reason for wanting this load is because I have a...
I have 500 primers that I would like to take to my brother. Will airlines allow me to have primers in my suitcase? Would they just treat them as ammunition?
If I asked someone at the airline... I trust it's not likely that they will understand what a primer is.
Has anyone purchased a custom rifle from Darrell Holland (http://www.hollandguns.com)?
I'm curious to hear what your experience was in dealing with him.
Thanks!
I want to have a custom rifle built and I need to supply a gunsmith with a left hand Remington 700 action to start the project. What is the best way to get one?
Remington doesn't sell them... nor does Midway or Brownells. In addition, Remington this year stopped making the SPS and BDL in...
I understand when you use a manual powder measure (like RCBS' Uniflow measure) that some kernals of powder will inevitably be crunched or crushed while dispensing large extruded type powders. With that... am I correct in assuming that some automated tricklers or dispensers (like the RCBS...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.