Search results for query: *

Back to top

Open to some small points, but a recommended method is to push forward. On some shotguns such as the Mossberg, pulling back can bind the action and delay unlocking the action. Second and more important a recommended recoil mitagation technic is to push out on the forend while drawing the stock...

I will be working on some write ups of this sample for a while. I'll try to keep the flow going to this thread to.

We talked with the MARSYSCOM reps at SHOT Show this year. They do know exactly what they want. The issue is that it does not exsist. The USMC is currently using two shotguns the M-1014 and the Mossberg 500/590 too fill all of their requirements. I think we are going to take a stab at providing A...

I talked with Mr. Stead a few times and others about the Neostead shotgun. It's not that they are illegal in the US, but rather they are not importable. They can be made in the US which I have looked into, but don't seem to be viable. They have a limited market and that would require some good...

the SRM-12 seems to have disappaired. I have not seen much about it since SHOT in 2008. But it looks like they will be released next year, maybe late this year. I handled it a SHOT 08. Intetresting design. The Monolith P-12 also seems to have gone poof. I can't even seem to pull up...

Techno Arms MAG-7, still in production in South Africa in several variants. Uses an odd 2" or so shell.

back to top

back to top

still looking

back to top

back to top

Anyone??

We carry those barrels for both the standard Mossberg and the 590s. We have a NFA 16" and two 18" models. I'm not realy a "retail" outfit, but do sell them to civilians. That said it sounds like what you need is just one of the 18" 590a1 models, or even a 835. Either will allow you to mount...

You know you could just get a 18" barrel for your 835 right? Add an extended Nordic Comp mag tube (or not) and you have a HD shotgun.

I may have heard a few things about the issue shotguns over the years: TC’ed and procured in the 1970s qualified under MIL-S-3443 thru rev E: Type I. With bayonet adaptor, heat shield and sling, (20" M-590) Type II. With sling only, (17/18 " 590A1/M-500/500MLS Primary Issue Shotgun for...

Those are the sights that were developed for the NYPD. NYPD uses them on 14" 590A1s and have had them in service a little over a year. They were LOOSELY based on pistol sights such as the ones from Novak. I believe they are still only availible through TALO distributors.

back to top

They are no longer in production so far as I know from any vendor. I am aware of one company that is looking into it, but I think in the end they will skip it. I got this one off of a board member and then had it installed.

Now the bad. At least with the A&W it does exactly what it was advertised for. Increase your chances of getting a hit: 7 yards #4 buck 15 yards, #4 buck You would get a hit, but likely not take any of the three out of the fight. Done again with 00 buck 7 yards 10 yards...