Just curious. Who runs a Remington 1858 (no conversion) without any lube
-- no grease cookie
-- no bullet lube
How many balls can you fire until the cylinder stops rotating?
I have read many times that there are different SAAMI standards for .223 and for. 5.56 NATO concerning pressure.
I do find SAAMI data on behalf of .223, unfortunately only in CUP. I dont find any SAAMI data for the 5.56.
Could someone please help?
I cleaned the dies on my LEE turret press and changed the disk on the LEE auto disk powder measure because i switched from N110 to 3N37.
With the disk set to .66 it should throw 7.2 grains bit it dropped only about 6.4. I did not just switch to the next larger disk because of:
This is the disk...
I did disassemble for the first time my new colt Walker from Uberti. I had problems to putt out the handle that is attached to the hammer. Putting hammer with handle back into the action(?) took quite a while ... i doesnt slide .
Is this an issue to all colt Walkers, is there a trick?
Thx, Elmar
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.