Are these solid rifles when compared to Ruger 10/22's and Marlin 60's? Are they more reliable and/or easier to clean than 10/22's and Marlin 60's? How is the accuracy of these rifles and also the trigger pull? They look like neat guns since they can cycle 22 shorts.
https://www.nraila.org/articles/20170322/arkansas-anti-gun-bills-reported-out-of-committee-and-headed-to-floor
Contact your Arkansas state senators and ask them to vote "No" on senate bill 724. Senate bill 724 will make it illegal to carry in additional locations with the new enhanced...
Has anyone tried this pistol out? I looked at one at a store and it is just a shade bigger than a Ruger LCP but feels like a solid gun. Any reliability or durability issues? I know Remington had issues with the 9mm in introduced a year or two ago.
Have there been any issues with the Ruger 22 45 Lite's finish flaking off or just not holding up since it is painted on aluminum? I have seen Smith and Wesson J frames clear coat finishes flake off.
I have been thinking about buying one of these guns but just concerned about the long term...
Have there been any problems with the finish of the aluminum upper Ruger 22/45 22 pistols? I have seen aluminum framed revolver's clear coat finish flake off.
Does anyone have a crossbreed supertuck for the Glock 17/22/31? How well does it hide the full sized Glock with khaki pants and a button up shirt tucked in?
Is the Hornady #2270 224 60 gr SP bullet the same bullet that is in the Hornady American whitetail 223 60 grain Interlock loaded ammo sold at Academy?
I looked on Hornady's website and it is saying the #2270 is a Varmint bullet.
There doesn't seem to be a 60 grain Interlock SP bullet...
What kind of accuracy are folks getting at 100 yards with the 55, 62 and 70 grain Barnes TSX 223/556 loads and standard carbine length AR 15's with 1:7 twist barrels?
I have thought about checking and then buying off the shelf ammo or reloading to use a 223 for deer.
Have any of you had good luck with Tac and Barnes 70 Grain TSX for a 223? I will be using this in a 1:7 twist carbine length barrel with a NATO chamber. I also have CCI 450 small rifle magnum primers. I've read good things about the Remington 7 1/2 small rifle primers but the CCI's were...
Has anyone used the Hornady 224 55 grain soft point W cannelure on small deer? We have a lot of 100 lb or smaller deer where I hunt and this seems to be a pretty inexpensive bullet.
I'm assuming it does not shatter like the VMAX or Nosler Ballistic tip varmint bullets?
Are any of you having good results with Ramshot Silhouette and 147 grain cast 9mm bullets? I am working up a load right now. I saw that the range is from 3.9 to 4.6 grains of Silhouette at COAL 1.145. I'm using a Missouri bullet cast 147.
I've tried 4.0 grains and will next try a batch of...
How difficult is it to pull back the slide on a Glock 42? I have looked at a Sig P290 380 and also a Ruger LC380 and both have slides that are pretty easy to pull back. I would compare the Ruger and Sig to a slide on a 22 autopistol. Is the Glock 42 slide as easy to pull back as the Ruger...
I have developed a moderate and accurate load of 62.5 grains of H4831, Remington brass, and Hornady 139 grain BTSP's. I bumped the shoulders back enough on the once fired factory cases so that they will chamber. What kind of brass life am I looking at? Do I need to use my lee collet neck...
I am thinking about an AR 15 and would like to know the accuracy difference between a Colt 6920 and a Colt 6720. I would put a quality scope on the rifle and shoot quality ammo or reloads. The 6720 looks good because it is lighter weight than the 6920, but if it doesn't group as well, not sure...
Would you nitride/melonite a rifle or cerakote one? I am thinking about buying a Remington Seven, Savage, or Tikka rifle and getting the rifle finished with something weather resistant. My big concern is the inside of the barrel and I realize that you can't put cerakote down the barrel. Is...
Both are similar in size. Glock 17 is a very common pistol. H&K VP9 just came out last year. What are the advantages and disadvantages of each? Will the H&K VP9 be able to win large law enforcement or military contracts in the future similar to Glock 17? Any known reliability or durability...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.